Note
Follow the instructions on how to flash the device carefully below
I will not take responsibility on whatever may happen to your device.
Flash at your own risk.
Make sure you are downloading the exact ROM of the device you want to flash because
flashing a wrong preloader, will make the device completely dead
(can't power on, can't charge and will not be detected by a computer)
SAMSUNG GALAXY J1 J100M STOCK FIRMWARE
To flash or upgrade this device with any of the firmware above,
Stage 1- Download and install samsung drivers from here
Stage 2- Download and launch the latest version of odin from here
Stage 3- Turn off your phone
Stage 4- Boot phone into download mode by holding vol down + home + power button
Stage 5- When you see the yellow triangle, press volume up to continue into odin mode
Stage 6- Now connect the phone to PC using USB cord
Stage 7- Wait for odin to detect the phone (you will see the COM Port)
Stage 8- Now click AP in odin interface then select the firmware
Stage 9- After the firmware is successfully loaded,
Stage 10- Click Start button
Stage 11- Wait for process to complete
Stage 1- When you see PASS in green then the process is complete.
Stage 12- Wait for the device to reboot
It’s always good to do a factory reset after doing this process
DOWNLOAD SAMSUNG GALAXY J1 J100M STOCK FIRMWARE
Reviewed by Gsm Kwinz
on
6/07/2018 03:13:00 am
Rating:
No comments: